C Shower FloorCyprus If using a device such as a Smart-Pan, it is to be installed to floor prior to waterproofing. Refer to section E. (3) 3 Floor board Lid Smart-Pan ti , l r . t Note: If renovating, pleasecheck floor boards for soundness. Rotting may have occurred and floor may need replacing. 3. Spread a 10mm min. thick mortar bed of 4:1Washed Sand Cement over entire area where the Cyprus Shower Floor is to be ins-talled and trowel off level, or use a cement base tile adhesive spread on floor with a 12mm notched trowel to ensure the whole area of the Cyprus Shower Floor is fully supported. Note: Do not use silicone and/or ‘Liquid Nails’ adhesive type to install the Cyprus Shower Floor! 4. Lay the Cyprus Shower Floor on prepared levelled mortar bed and using a spirit level ensure the Cyprus Shower Floor is level both side to side and front to rear. This will allow the Cyprus Shower Floor to drain effectively as it has inbuilt fall to the waste outlet. Ensure the Waste Outlet is positioned accurately above your drainage aperture! 5. At this point it is imperative to test for water run-off to the waste outlet prior to lining shower walls. This will ensure the Cyprus Shower Floor is draining correctly. 6. Once set, install the Waste outlet into the Cyprus Shower Floor. Note that the outlet is to be threaded in the anti-clockwise direction from the top of the Cyprus Shower Floor. Refer to waste outlet instructions. C2. INSTALLATION in a Concrete Slab In new installations, it is possible to recess the Cyprus Shower Floor into the floor in order to achieve a step-free surface, however it is important to ensure that the Cyprus Shower Floor edges are a minimum of 3mm away from the surrounding surfaces, and are sealed all around. (4) 4 Tiles or floor cladding Sealant Tile adhesive or mortar bed Shower Floor Waterproofing 32