Therefore, if you wish to change the 3 settings of the anal cleaning, by instance, they should be pressed successively with the activated function Should you need to connect the remote control again these stored values would be lost. To return to the pre-set standard values, see section 3.5. 3.4.2 OPERATING MODES LED LIGHTS There are four operating modes for light in the In-Wash® : Mode 1 Standard: This is the pre-set mode of the product. The lights remain switched off while the In-Wash® is not in use. When the cover is lifted, the lights are switched on. They remain switched on while the product is in use and they switch off one minute after they stop detecting the user. Mode 2 Standard with night light: When this mode is activated, the lights of the In-Wash® switch on daily for 8 hours and during the remaining 16 hours the In- Was h® remains in Standard mode. Mode 3 Night light: When this mode is activated, the lights of the In-Was h® switch on daily for 8 hours and they remain switched off for the remai- ning 16 hours. Mode 4 Switched off: Lights always switched off. The Light mode may be modified by means of the auxiliary side control: • Press the Dryer button on the auxiliary side control for 3 seconds. A beep will be heard and the lights will blink indica - ting the mode of the In-Wash® ; 1 blink + 1 beep mode 1, 2 blinks + 2 beeps mode 2 and so on. • Press successively the Dr yer button to change the mode 1, 2, 3, 4, 1, 2, 3, 4... until you reach the desired mode. The lights blink 1, 2, 3 or 4 times indicating the selected mode. • With the selected mode, press the St op button on the auxiliary side control or the remote control, to memorise the option, or wait one minute and the last selected mode will be registered. 13