❚ 2.2 START-UP 2.2.1 CONNECTION OF THE REMOTE CONTROL AND SELF-CALIBRATION To connect the remote control to the In-Wash® it is necessary to: 1 2 3 4 5 ON SAEULTFO--CCAALLIIBBRRAACTIIÓONN Max. 60 s. CR 2032 (x2) 5 s. 120 s. 1- Place the batteries inside the remote control. 2- Open water supply valve 3- Activate the power to supply the In-Wash® . 4- After connecting the power, you have 60 seconds to link the remote control, pressing simultaneously the Drying and Stop buttons on the remote control for 5 seconds. 5- A beep will be heard and all the LEDs on the remote light up, as a signal that it is connected. A self-calibration process starts for 120 seconds during which water flows from the e-bidet nozzle window. Do not disconnect the device during this process. Should the connection be incomplete, repeat the process starting from step 2. 2.2.2 USE OF THE PRODUCT The In-Wash® has a small internal water tank that is cold in stand-by conditions. When the user detector detects a seated user, the preheating process is activated. The preheating takes place at 36º. The functions may be activated at any time, but if they are activated too soon, the water will not have time to reach the established temperature; therefore it is recommended a minimum preheating period of 30 seconds from the moment the In-Wash® detects the user until any water function is activated. When a function is activated, the In-Wash® carries out a cleaning of the nozzle before its use. When the function is finished, a subsequent cleaning process of the nozzle takes place for 10 seconds. 8