3.3.1 ANAL CLEANING WITH AUXILIARY SIDE CONTROL The position of the nozzle is established beforehand; so is the water temperature. With the function activated, by pressing the same button again the oscillating function is activated. If it is pressed again, it returns to the normal mode (not oscillating). To stop this function, press the Stop button on the auxiliary side control or on the remote control. The cleaning stops after 2 minutes if no other button is pressed. If the drying button is pressed while the anal cleaning is taking place, the cleaning stops and the drying is activated. 3.3.2 DRYING WITH AUXILIARY SIDE CONTROL The drying function is established beforehand with a medium temperature. To stop this function press the Stop button on the remote control or the auxiliary side unit. The drying stops after 3 mi- nutes if no other button is pressed. 3.3.3 STOP WITH THE AUXILIARY SIDE PANEL It stops any activated function. ❚ 3.4 CHANGE IN THE PRE-SET SETTINGS 3.4.1 CUSTOMISATION OF THE CLEANING AND DRYING SETTINGS The In-Wash® allows you to change the pre-set Temperature, Pressure and Position settings, which are controlled by the remote control By default, these baseline values are: • Medium temperature: 36º perineal and anal. • Medium pressure: 0.55 L/min in perineal, 0.75 L/min in anal. • Position- 3 Perineal, 3 Anal. To set a different value to the pre-set one, with the activated function, adjust each of the temperature, pressure or position para- meters to the desired level and press the + and - buttons simultaneously on the remote control for 3 seconds. Each temperature, pressure or position parameter needs to be set individually. When the setting has been carried out, the In-Wash® emits a beep and the lights in the remote control blink. 3 s. x2 12